Round%20Corner%20Stainless%20Steel%20Brushed%20Brass%20PVD%20Coating%20Single%20Bowl%20Kitchen%20Sink(With%20Bottom%20Grid)%20250*450*215mm?unique=412a238&nocache=mydepot_wm_blue_soft)
Barcode:
41557
MyDepot product guide
Brushed Brass PVD Single Bowl Kitchen Sink
A compact single bowl kitchen sink featuring a brushed brass PVD coating. Designed with round corners for a modern look.
What is included
| Included | Sink unit Bottom grid |
|---|---|
| Not included | Installation service and site preparation are not included unless stated separately. |
| Best for | Smaller kitchen cabinets or secondary kitchen areas requiring a compact single bowl sink in a brushed brass finish. |
Measure before you buy
- Confirm cabinet interior width accommodates the 250mm sink.
- Ensure the 450mm depth suits your base cabinet.
- Allow adequate height clearance for the 215mm bowl depth.
- Confirm waste outlet position matches your plumbing.
- Check tap hole drilling requirements.
Complete specifications
| Product type | Single Bowl Kitchen Sink |
|---|---|
| SKU | 41557 |
| Code | 41557 |
| Size | 250 x 450 x 215mm |
| Material | Stainless Steel |
| Colour / finish | Brushed Brass PVD |
| Barcode | 41557 |
Factory-direct confidence
MyDepot focuses on practical bathroom and home products with clear specifications and direct value. The goal is simple: make the renovation decision easier, not louder.
Care and installation notes
- Clean with a soft cloth and mild soapy water.
- Avoid abrasive cleaners, scouring pads, or steel wool on the PVD coating.
- Rinse and dry after each use to maintain the brushed finish.
- Do not use harsh chemicals or bleach-based cleaners.
FAQ
What is included with this sink?
The package includes the sink unit and a bottom grid.
What cabinet size is required?
The sink width is 250mm. Please confirm your cabinet interior width accommodates the sink and allows for necessary fixings.
Is this sink suitable for undermount or topmount installation?
Please confirm the intended installation type with your installer before ordering, as cut-out requirements differ between topmount and undermount.